The market competition in the light touch switch industry chain is very fierce. Sometimes, the inspected objects are turned one by one towards the photoelectric switch at a certain interval, and then leave one by one, constantly repeating that process.

1. When the manufacturer of the light touch switch conducts welding on the terminal blocks of the light touch switch, if the load is released on the terminal blocks, there may be looseness, deformation, and deterioration of electrical characteristics due to different standards. Please pay attention when applying.

2. When using buried hole printed circuit boards and circuit boards other than those strongly recommended, due to changes in the hazards of welding stress, please conduct sufficient determination of welding standards in advance.

3. When conducting two rounds of welding, please repair a part of the first round of welding to room temperature before proceeding. Continuous heating will cause deformation of the external field, loosening and falling of wiring terminals, and reduced electrical characteristics.

4. Specific mass production standards must be determined for the standard setting of electric welding.

5. The product is designed and manufactured with the premise of DC resistor load. When applying other inductive loads, capacitive loads, please confirm again.

6. For the installation holes and methods of printed circuit boards, please refer to the strongly recommended specifications described in the product pictures.

7. The manufacturer provides a detailed introduction to the structure of the power switch, which can be immediately operated by humans. Please do not use it as a reflective test.

When lightly touching the switch for actual operation, if the required load is released, the power switch may be damaged. Reminder: There is no need to release the required force on the power switch.

9. Please avoid following the actual operating instructions from the side.

10. For the flat shaft rod type, try to hold down the power switch management center as much as possible. Regarding the hinge structure, the pressing part of the shaft rod will move when pressed down, please note.

11. After the installation of the power switch, please contact a professional when using the heat storage hard bottoming furnace due to the adhesive hard bottoming of other components.

If the surrounding raw materials of the entire equipment using the power switch cause corrosion vapor, it may lead to loosening and other conditions. Therefore, please conduct sufficient confirmation in advance.

13. Carbon point contact has the characteristic of changing contact resistance due to pushing load. When using the control circuit of the working voltage divider circuit, etc., please apply it after sufficient confirmation.

14. The manufacturer of the touch switch provides detailed information on models and specifications other than the enclosed type. Please pay sufficient attention to the invasion of dirt.

The dual color strip light touch switch, as the name suggests, refers to a light touch switch with two LED colors, which can be divided into two categories: one is a dual light dual color strip light touch switch, such as dual light red blue, dual light red green, dual light red green, etc; Another type is a single light dual color strip light touch switch, such as red blue, red green, etc.

The dual light dual color switch and the single light dual color switch can be directly distinguished from each other in terms of appearance. One is a single light, and the other is a dual light; A single lamp has two lamp legs (one positive pole and one negative pole, usually labeled as the negative pole), while a double lamp has four lamp legs, corresponding to the positive and negative poles.

The difference in function between the dual light dual color strip light touch switch and the single light dual color strip light touch switch: the dual light dual color strip light touch switch allows both lights to light up simultaneously and emit different colors, achieving different control functions; The single light dual color strip light touch switch needs to emit different colors through reverse connection of positive and negative electrodes to achieve the design function. Although they differ in size, appearance, and function, both can enhance the aesthetics of product design, and their quality is stable, making them the foundation of many engineering designs.